Beginning some interior work

I began to use MDF board to construct the interior. The first project would be to have two vertical walls behind the seats, to separate the "passenger compartment" where one sits while driving, from the living compartment where one is when staying somewhere.

I did make use of the floor railings and attached the walls on these rails, so that one would be able to move these walls later.

First I created a cut-out around a floor socket which looks like it is for a table. This socket had been under seats and was not used for its intended purpose. I was not able to remove it, the screws were very tight. So I left it in place and cut the floor board around it.

The leisure battery #1 is located behind the double seat on the right-hand side of the vehicle.

In the picture above the heater outlet can be seen. This outlet actually does work: when it is switched on, it produces warm air from the vehicle engine coolant which is led through it.

It is getting dark. The vertical post is attached to the floor board outside of the bus, then the board is carried into the bus and is attached to the floor railings. This is for the wall on the right-and side of the vehicle: